Which pan world for my mixing station

  • Thread starter Thread starter ToneReef
  • Start date Start date
  • Tagged users Tagged users None
I use a Pan World NH-150PS on my mixing station.

Full details and a complete parts list for my mixing station here: https://www.reef2reef.com/threads/suncrestreefs-red-sea-reefer-xl-425-build.358990/post-6173194

IMG_2686.jpg
Thanks @suncrestre. I did previously look at your build and explanation. It helped a lot. I just need to find out how the line purging works with a little bit of fresh water to drain old dirty water, and how the dirty water exits from drain end (to where)? Obviously, you dont want to contaminate the new mixing station water and a ball valve is used on the fill line at the DT. I figure that closing the ball vale on fill line will stop dirty water water from back flowing to mixing station, but do I need to physically do at the mixing station? Disconnect the drain line from the mixing station and put it in a floor drain?
 
Could I use this setup but run water to the tank using an RO line? Would that be too much back pressure on the pump? Not interested in running water from the tank, only from mixing station to tank. 10’ vertical and probably 30’ horizontal
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.9%
  • Fish or coral food

    Votes: 5 5.6%
  • Test kits or reagents

    Votes: 9 10.0%
  • Filter media or replacement fleece

    Votes: 5 5.6%
  • RO/DI filters or supplies

    Votes: 14 15.6%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.1%
  • I keep a backup of everything

    Votes: 23 25.6%
  • Other (Post in the comments)

    Votes: 7 7.8%
Back
Top
Home
Post thread…
Market
What's new