XP Aqua RO/DI Flood Guardian Setup

[dbleoh7]

Can someone help me out with setting up my XP Aqua RO/DI Flood Guardian? I'm confused as to where to put the solenoid. I attached a pic of my RO/DI. I think the instructions imply it's supposed to go between canister 1 and 2 in my diagram. but there is no space to put it. Will there be any harm in connecting it at the very end (after the last canister) where the water goes out to the storage container?

 

[BlennyTime]

The instructions show it installed in-line with the input to the RO membrane, which is #4. The big end on the left is the input, and the right is the output. There is a tubing there (the blue tubing on the far left), that’s where it should go. You would disconnect that tubing and tie it in there.

 

[Dennis Cartier]

Unless you have an auto shutoff valve installed. In that case, you can put it at the storage container. I don't see one in your photos though.

Dennis

 

[dbleoh7]

The instructions show it installed in-line with the input to the RO membrane, which is #4. The big end on the left is the input, and the right is the output. There is a tubing there (the blue tubing on the far left), that’s where it should go. You would disconnect that tubing and tie it in there.

So put it between 3 and 4 then right?