Zetlight 6600A

[Dumaurier7]

Hello , my 6600A lights were controlled by the APEX VDM module , would the PROFILUX be able to ? if so what modules / adapters would be necessary ? thanks.

 

[Dumaurier7]

Anyone?

 

[Vinny@GHLUSA Verified Sponsor]

The VDM module is equivalent to the Profilux built-in L ports. We are looking into the specs of this light and will get back to you asap.

 

[Dumaurier7]

Ok, thanks for the response.

 

[Dumaurier7]

The light has 4 channels and it uses their advanced dimming cable, the module has two different types of ports, two last me yours and one 9 pin D shaped serial .

 

[Dumaurier7]

 

[Dumaurier7]

Anything?

 

[Matthias Gross Verified Sponsor]

Hi, I think these are just 2 simple 1-10V-interfaces, right?

In this case you have to find out which pins carry the 1-10V signal and GND.

Then you could use our interface box LBF-AP for easy wiring:
https://www.aquariumcomputer.com/products/ghl-illumination/illumination-accessories/

It has 4 screw terminals (2 channels with 1-10V and GND each)

 

[Dumaurier7]

Hi, I think these are just 2 simple 1-10V-interfaces, right?

In this case you have to find out which pins carry the 1-10V signal and GND.

Then you could use our interface box LBF-AP for easy wiring:
https://www.aquariumcomputer.com/products/ghl-illumination/illumination-accessories/

It has 4 screw terminals (2 channels with 1-10V and GND each)

Maybe not its got four sets of leds and four channels , white , blue , coloured and moon.

 

[Matthias Gross Verified Sponsor]

in this case you would need 2x of the built-in 1-10V ports (have 2 channels each) and 2 LBF-AP

 

[Dumaurier7]

For each fixture ? if so it would mean I would need four in total! The other system used one module per fixtuire , Is there any other module or controller available from GHL which can be utalized to keep the number of "boxes" to a minimum ?

 

[Matthias Gross Verified Sponsor]

for every 2 channels you need one ProfiLux port resp. one LBF-AP

if you run 4 channels in a fixture parallel to 4 channels in the other fixture you need 2x LBF-AP

if you want to dim all 8 channels independently you need 4 LBF-AP (and 4 ports, of course)

 

[Dumaurier7]

Bummer ! I guess it's off to the forsake section then ![emoji51]

 

[ReefRocker]

Look at it this way, at least you'll know be able to pick up the new Mitras LX7 leds and connect them to the ProfiLux. :)

 

[Dumaurier7]

Yup[emoji844][emoji106]

 

[Dumaurier7]

Bump

 

[Dumaurier7]

One fan died on each of them so I'll let them go for $275 and I'll include 3 fans I bought off eBay!