Thats quite a long time! Show us your AWC and ATO setups
I have an Apex Pro 3 and 5 Dōs connected to my Mixing Station. Everyday each Dōs pulls out 1/7 of 10% of each display tank and drains it to the sink. It helps me detect blockage when I can visually see each line draining.
At the same time each Dōs is adding 1/7 of 10% to each display tank.
The RO/DI tank is in the middle. The freshwater Discus reservoir is on the right. The saltwater reservoir is on the left. Each tank holds approx 108 gallons. Every day a water change is done on 3 saltwater tanks and 2 freshwater tanks. When I did manual water changes it too all day every saturday and was messy and tiring. Now water changes are effortless. Just monitoring them. Even refilling 5 ATO reservoirs was a huge chore. It is now effortless.
Under each display tank I have an ATO reservoir. The Booster pump you see above the shelf over the RO/DI reservoir automatically tops off the ATO reservoirs under each display tank. It runs 20 minutes each day. It keeps all the ATO reservoirs topped off.
I have alot of problems programming Apex. It is very difficult for me to learn, understand and retain. I have Hydros controllers on each display tank. They are easy and intuitive for me. I started with one of each to compare and contrast. I greatly prefer Hydros.
I used to control the circulation pumps and heaters in the mixing station reservoirs through the Apex. I switched them to the Hydros XS controller with the Hydros XP8 power bar because even after a year I still struggle with getting Apex to do what I want.
The Apex now just controls the Dōs pumps and the RO/DI setup. Because I am on a well I have a buddy booster pump to bring the water pressure up. When my reservoir low sensor is tripped, the apex turns on the RO/DI. When the high sensor trips, the Apex turns it off. I could not figure this out myself. I got William Reed of
BRSTV to program my Apex. That guy is AMAZING and unbelievably generous with his time and knowledge.
