Aluminum t-slot deflection

[Gp!]

Sitting in the hospital thinking about hanging equipment. I don't have access to a computer at the moment.

Does anyone have deflection numbers for any of the t-slot profiles.

For example, a 5' length of 4 way x 1" t-slot. What weight causes 1/8" bend. 1/4" bend. Etc or anything similar.

Thanks!

 

[Stang67]

Sitting in the hospital thinking about hanging equipment. I don't have access to a computer at the moment.

Does anyone have deflection numbers for any of the t-slot profiles.

For example, a 5' length of 4 way x 1" t-slot. What weight causes 1/8" bend. 1/4" bend. Etc or anything similar.

Thanks!

I think if you go online to the t slot catelog there is a page that gives you that info. I will see if I can find a link.

 

[Stang67]

Sitting in the hospital thinking about hanging equipment. I don't have access to a computer at the moment.

Does anyone have deflection numbers for any of the t-slot profiles.

For example, a 5' length of 4 way x 1" t-slot. What weight causes 1/8" bend. 1/4" bend. Etc or anything similar.

Thanks!

TSLOTS Aluminum Extrusion Manufacturer

Need quality aluminum T-slotted extrusion manufacturers? Bonnell Aluminum is the nation’s largest manufacturer and distributor quality aluminum extrusions.

www.tslots.com

 

[air_run]

Here's the one I use for all my 80/20 (T-Slot Aluminum) projects.

Beam Deflection/Displacement Calculator | 80/20 Aluminum Extrusions

Use this calculator to determine the deflection or displacement of 80/20 T-Slots profiles with one fixed end, two fixed ends, or a load supported on both ends.

8020.net

 

[Gp!]

Here's the one I use for all my 80/20 (T-Slot Aluminum) projects.

Beam Deflection/Displacement Calculator | 80/20 Aluminum Extrusions

Use this calculator to determine the deflection or displacement of 80/20 T-Slots profiles with one fixed end, two fixed ends, or a load supported on both ends.

8020.net

Thanks that calculator tells me exactly what I'm looking for

 

[servus]

@Gp! I am curious what you ended up going with? What deflection and why?

 

[Gp!]

@Gp! I am curious what you ended up going with? What deflection and why?

I went with 1010.

These were for sliding equipment racks - mainly lights and sump stuff. That is a standard size that let me reuse tooling and hardware I use for other things.

I ended up checking deflection against cad models but it was minimal for my needs. The 1515 profile would have been stronger but this is mainly cosmetic - more than an 1/8" is usually visible for lots of people.

If it was for levelling a tank stand I would have wanted at least 1/16" or 1/32" so that the tolerance of the level was the weakest link.

 

[servus]

Thank you for your reply! That helps.

 

[RobertK]

I'm thinking of using this stuff, it says its 5x stronger than aluminum, and it doesn't conduct electricity.

McMaster-Carr

McMaster-Carr is the complete source for your plant with over 595,000 products. 98% of products ordered ship from stock and deliver same or next day.

www.mcmaster.com

Edit: Oops, I posted this in the wrong thread. Doh!