APEX ATK STANDALONE ERROR

[jfbhd4]

SET UP MY ATK IN STANDALONE MODE AND THE PUMP TURNS ON AND EVERYTHIGN WORKS, UNTIL THE WATER HITS THE SENSOR, THEN IT GOES INTO ERROR MODE AND BLINKS RED. ONCE I CYCLE THE POWER, IT GOES BACK TO REGULAR FUNCTION MODE. ANY IDEAS?

 

[vetteguy53081]

@SuncrestReef

 

[SuncrestReef]

Which sensor is the water reaching? If it’s going up to the higher sensor, then that’s the problem. It could be the lower sensor is failing to detect the water level.

Ensure both sensors are fully seated in the FMM socket. Give each plug another push to see if they click into place.

 

[jfbhd4]

Returning this thing. Impossible to get to work.