Apex Classic Resetting all outlets problem

Dylan Grech · Mar 8, 2018

Hi,

I have an Apex classic gold with 2x energy bars (6 outlets), salinity probe & ATK. Everything is updated to the latest firmware.

I have this very weird problem which started a few days ago and cannot figure out what's wrong.

The apex will just turn all outlets to OFF and back ON after 2-3 seconds. The whole system stays on so it's not a power surge else the fuse / breaker would go off. It can't be programming either as I didn't change anything in weeks.

ihavecrabs · Mar 9, 2018

Dylan Grech said:
Hi,

I have an Apex classic gold with 2x energy bars (6 outlets), salinity probe & ATK. Everything is updated to the latest firmware.

I have this very weird problem which started a few days ago and cannot figure out what's wrong.

The apex will just turn all outlets to OFF and back ON after 2-3 seconds. The whole system stays on so it's not a power surge else the fuse / breaker would go off. It can't be programming either as I didn't change anything in weeks.

I take it that all your programming remains intact, just changes from OFF to ON?

Dylan Grech · Mar 9, 2018

ihavecrabs said:
I take it that all your programming remains intact, just changes from OFF to ON?

Yup it's like a "reset" signal but only on the energy bars which is super weird.

ihavecrabs · Mar 9, 2018

That is very weird.

#reefsquad any ideas?

vic5hands · Mar 9, 2018

What is the default?

GoVols · Mar 9, 2018

Dylan Grech said:
Yup it's like a "reset" signal but only on the energy bars which is super weird.

Dylan,
Can you still get into Fusion?

jsker · Mar 9, 2018

Go into the apex via a browser and check and see if all the components updated. I had this happen once and one of my power bars was not acting correctly