I have a 40b with about 20g in the sump for total water volume of 60 gallons. Recently I had heater die (not a big issue since take is just FOWLR at the moment. I am using twin titanium 200w BRS heater elements plugged into a BRS heater controller. So last week when my heater went out it was actually the second heater dying.
I went back in Neptune Apex Fusion and looked at that outlets wattage and I think I've identified when the first heater died back mid december. Then this week the second one went.
So my question is this:
How do I adjust the alert parameters to get a notification when the outlet isnt putting out over 400w. When the one heater dies the max output will be ~200 watts and I'd like an alert so I can figure out when I am down to a single heater element.
I went back in Neptune Apex Fusion and looked at that outlets wattage and I think I've identified when the first heater died back mid december. Then this week the second one went.
So my question is this:
How do I adjust the alert parameters to get a notification when the outlet isnt putting out over 400w. When the one heater dies the max output will be ~200 watts and I'd like an alert so I can figure out when I am down to a single heater element.