Apex... Module error on (Missing)

[Jesse Sunday]

Hi Apex Gang! :)

So I bit the bullet last night and replaced my Hydra HDs with Hydra Edge 44s but in doing so, I removed the HDs from Mobius not knowing that it would cause a repeated Module error on (Missing) notification...

I've tried re-adding the HDs through Mobius, re-removing them... restarting the Apex... restarting all devices, etc.

However, Fusion is still constantly showing the Module error on (Missing) message.

Anyideas?

Here's what I have connected through the MXM, and lots of programming between all those devices, so I don't want to "delete" the MXM if it won't re-add with all devices and programming intact.

 

[Jesse Sunday]

 

[Jesse Sunday]

Any suggestions before I delete the MXM and re-add? :(

 

[Jesse Sunday]

Well, I'm impatient... deleted the MXM from Fusion. Re-added. Still the same error. :(

 

[Bartanto]

Did you figure this one out? I had two Nero 5’s simultaneously go ‘missing’ from fusion and can’t reconnect. Thx!!

 

[Jesse Sunday]

Did you figure this one out? I had two Nero 5’s simultaneously go ‘missing’ from fusion and can’t reconnect. Thx!!

Hey there, I did eventually figure it out! It was total user error, inasmuch as I had added a manual alarm in the "base_email" section... essentially "If Error [name of the module I subsequently removed] Then ON"

Once I removed that line, all was fine. :)

 

[bkwonnn]

I have had issues with FFM modules disconnecting; even the internal FFM module. I believe that to be EMI. Electrical magnetic interference. Adding a ferrite core to the aqua bus cables solved that issue for me.

 

[bkwonnn]

Also random disconnect of WiFi etc