BRS 2-Part Soda Ash dissolving

[GuppyHJD]

Hello,
I have been using BRS 2-Part for several years. Yesterday I mixed a gallon of ALK (Soda Ash). I used a pre-measured container of Soda Ash, followed the directions and poured the Soda Ash into 3/4 gallon of RODI. Shook until dissolved. Then topped off with RODI. Today, I hear some sediment of the Soda Ash that did not fully dissolve. I have tried shaking (ALOT), but am not getting it to dissolve. BRS Support answered that I should add more RODI until it dissolves or pour off the clear solution into another container and use that to dose. Suggestions?

 

[rtparty]

Can you warm it up in a warm water bath? That may help the last little bit dissolve

 

[Randy Holmes-Farley]

How much sediment?

 

[mook1178]

Is your soda ash pure? If it does not dissolve from warming up as suggested, it is either impurities or precipitation from sometime already in the water. Check your RODI.

 

[GuppyHJD]

How much sediment?

2-3 tablespoons, little pebbles

 

[Randy Holmes-Farley]

2-3 tablespoons, little pebbles

I'd probably just ignore it. It may dissolve over time, or not.

 

[spsick]

I have to warm and shake mine a ton to get it all dissolved. I have a 2g bucket to give my 1g jug a warm soak before I add the soda ash and then it works better.