BRS ro/di pressure gauge

[chevy4w]

I use the BRS 4-stage to make my water and the unit has worked fine for 3 years now. However this morning I went to make some water and the gauge was stuck at 10 psi. I know the pressure in the house is good, always has been. So, I watched the TDS meter throughout making this water and all was good there. Then I shut the unit off and the gauge is still reading 10 psi. It seems to be stuck. Any way I can fix this or do I need another gauge?
Also, as I write this post I am flushing the membrane. Don't know it that's going to make any difference but I thought I'd try any way. Any input will be appreciated.

Bill

 

[sstewart81]

Sounds like the gauge is broke.

 

[kgstei]

sounds like the pressure gauge is bad. my thought would be as long as the TDS is fine and you should be good to go

 

[shiftnation]

You can try pulling the gauge and flushing it with vinegar. If not its common for water gauges to go bad over time. Hard water speeds up that process.

 

[chevy4w]

Thanks for the input. They're cheap enough so probably purchase another one.

 

[Vaiodude]

Mine is a BRS 4 stage and the gauge stopped working after several months.

 

[Collinslice]

Thanks for the input. They're cheap enough so probably purchase another one.

Most of the gauges shipped standard are air filled. If you want a more reliable option, get the oil filled gauge.
On our barracuda at the store, the pressure gauge somehow pinned itself below the 0 and can't hop over that metal post to work again