So I finished the plumbing on my office tank yesterday. This morning I started water testing by putting a some water in the overflow boxes. A bulkhead on each overflow is leaking.
Because of how small the holes in the stand are, I would have to cut out the plumbing to be able to tighten/loosen/remove the bulkheads. I'd rather avoid that if I can.
The tank is acrylic, so I don't think silicone would work.
Anyone have any suggestions on how I can fix this without having to cut the pluming out and starting all over?
Because of how small the holes in the stand are, I would have to cut out the plumbing to be able to tighten/loosen/remove the bulkheads. I'd rather avoid that if I can.
The tank is acrylic, so I don't think silicone would work.
Anyone have any suggestions on how I can fix this without having to cut the pluming out and starting all over?