CO2 scrubber review

[enzo86]

I didn't even know they had a DC version. Live and learn.
My "Y" adapter is coming tomorrow. Can't wait to get the solenoid on.

I know this is a really old thread, but anyone ever consider just running a part of your fresh air feed with PVC, then just using a cheap sprinkler valve ?

https://www.amazon.com/Orbit-57281-...7301&sr=8-7&keywords=electric+sprinkler+valve

 

[Chris155hp]

Bump following

 

[The Big Chill]

Question: Can you simply take an air pump, plug one end to the BRS CO2 scrubber Canister and run a tube from the other end of the canister to a limestone mini airstone. Then place that airstone into your sump and/or refugion. Will that do the same thing as plugging into the protein skimmer and essentially bringing your PH up?

 

[Randy Holmes-Farley]

Question: Can you simply take an air pump, plug one end to the BRS CO2 scrubber Canister and run a tube from the other end of the canister to a limestone mini airstone. Then place that airstone into your sump and/or refugion. Will that do the same thing as plugging into the protein skimmer and essentially bringing your PH up?

Because you have a skimmer and don't want to use it, or do not have a skimmer?

Any aeration via the scrubber will be in competition with other aeration using higher CO2 air, such as the tank top and a skimmer, if it is not being used for the scrubber.

Airstones can aerate OK, but have issues with salt spray and may not be as effective as a skimmer. In a closed sump with a lid, an airstone might be especially useful.

 

[The Big Chill]

Because you have a skimmer and don't want to use it, or do not have a skimmer?

Any aeration via the scrubber will be in competition with other aeration using higher CO2 air, such as the tank top and a skimmer, if it is not being used for the scrubber.

Airstones can aerate OK, but have issues with salt spray and may not be as effective as a skimmer. In a closed sump with a lid, an airstone might be especially useful.

Thank you for your reply Randy.

Correct.... I have a protein skimmer and already have that airline routed to the outside of the house. I am receiving the CO2 scrubber this week and was looking for other ways to implement it alongside the current Skimmer setup. If I need to cut the line and just put the CO2 scrubber in between the outside line and skimmer that is fine also. I already have an air pump and limestone airstone for mini bubbles. Was curious of the PH effect of running that setup (stone in covered sump) in parallel with current skimmer setup. If it was overkill and/or one would diminish the positive PH effect over the other.

 

[tomb18]

Can the 24v solenoids be run off the 24v output of the Apex?
Tom

 

[lavoisier]

If you don't mind me asking
How much did 40 pounds of media cost ?
Trying to figure out if this would be affordable to maintain as a permanent fixture on a large reef

This is about as inexpensive as I have found for 50lbs: Amazon product

 

[BiggestE222]

Since adding my 2nd MP40 to my Red Sea 200 there has been better flow but a lot of surface agitation. Received my Milwaukee PH controller. Shocked to see a ph of 7.8. So we will see if mire dosed Kalkwasser and the co2 scrubber will help