Purchased a new tank that was built wrong. Thinking I could remove over flow glass, install bulkhead and reset glass I cracked the tank. Went at it for an hour with razor but one side is to tight to get razor in. So thought I would hit it from the outside with torch and burn off the silicone. I went hard with the heat and snap, glass cracked.
is it trash? How am I going to remove this over flow to get bulkhead in?
first thought is to add support glass to inside and outside, but crack is at the return bulkhead. Best bet would be install bulkhead at the same time I add support glass.
is it trash? How am I going to remove this over flow to get bulkhead in?
first thought is to add support glass to inside and outside, but crack is at the return bulkhead. Best bet would be install bulkhead at the same time I add support glass.