I just got an Ecotech Battery Backup for my 2 mp40s. I am running the pumps off an apex with a wxm module. Is there a way to turn the pumps off with the apex still or run a feed mode without the backup turning on simulating a power outage??
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Unfortunately my pumps are pre mobiusI believe the feed mode function should still work and that would not trigger the battery backup. However, no way to shut them off without battery backup kicking in.
Honestly, I’d swrirch to mobius control. There you have a built in feed mode (that you can edit) as well as a feature that will shut down all of the pumps without having the backup kick in.
Both of my mp40s are in auto and feed modes just have the simple code. I’ve attached a picture. I do have the pumps plugged into the apex energy bar only because my wall outlet as two sockets and two energy bars. I can maybe change thatIf your WXM is properly setup, you should have a control in Apex Fusion that lets you turn-off the pump. This control works by sending an 'off' command through the WXM to the pump. Even if you have battery backup connected to the pump controller, the pump will stop. I have circled the proper controls (for my system) in the attached photo. My controls (for WXM Vortechs) are named DTLVORTECH and DTRVORTECH. Notice that I have additional controls for the outlets that the Vortechs are plugged-into (DTLVORPWR and DTRVORPWR) and controls for the outlets where the battery chargers are plugged-into (DTLVORBATT and DTRVORBATT). It is NOT necessary to have Apex Outlets for the Vortech and Battery power feeds.
Thank you so much @FFFishy! That fixed my issue! Ive been incorrectly using the outlet to control to muchYou need to make a little change. Put the "IF FeedA 000 Then OFF" and "IF FeedB 000 Then OFF" in the setup for the VORTECH_R and VORTECH_L Outlets. You do NOT want "IF Feed....." to be in the setup for LEFT_MP40, RIGHT_MP40, BATTERYBACK.
What you currently have will turn-off power to the outlet that powers the Vortech controller, and as you have seen, the battery takes over with the pump continuing to run. Make the change I've noted above, and the Apex will send the OFF command through the WXM without the battery causing it to remain running.