Giant Clam seeds?

VERY difficult, especially if you decide on maxima/crocea.
 
“Acro Al” Allan Van Zijl in Perth, Australia did, but from what I recall, he was only able to do so effectively without taking up too much space because he lived in close proximity to the ocean (from what I remember, I could be off on this). Like the others have said, though, it definitely isn’t an easy task.
 
From reading a paper on how a commercial hatchery does it, it's not by any means impossible, but it is probably tricky. Lots of space and high light so the larvae can settle, then a way to get zooxanthellae into the babies - but the method described is to blenderize an adult and inoculate the water with it... so there's considerable investment.

The basics are that it takes a while to get spawning age clams, then getting their larva to survive is not so bad without pumps, but the initial settling requires some phytoplankton, a source of zooxanthellae for their mantles, and a lot of light (typically shallow waters in partly shaded full tropical sun). I think it's not overly challenging to do, but it may be very difficult to make a small scale experiment work out well.
 

TOP 10 Trending Threads

WHEN NUISANCE ALGAE OR CYANO FIRST APPEARS, WHAT DO YOU DO FIRST?

  • Manually remove it and observe

    Votes: 9 22.0%
  • Retest nutrients and other parameters

    Votes: 9 22.0%
  • Adjust flow or lighting

    Votes: 1 2.4%
  • Reduce or change feeding

    Votes: 0 0.0%
  • Add or strengthen the cleanup crew

    Votes: 6 14.6%
  • Improve filtration or nutrient export

    Votes: 2 4.9%
  • Use a targeted treatment

    Votes: 0 0.0%
  • Wait and let the tank find its balance

    Votes: 11 26.8%
  • Phone a friend...

    Votes: 0 0.0%
  • It depends (explain in the comments)

    Votes: 3 7.3%
Back
Top
Home
Post thread…
Market
What's new