Giant Clam seeds?

VERY difficult, especially if you decide on maxima/crocea.
 
“Acro Al” Allan Van Zijl in Perth, Australia did, but from what I recall, he was only able to do so effectively without taking up too much space because he lived in close proximity to the ocean (from what I remember, I could be off on this). Like the others have said, though, it definitely isn’t an easy task.
 
From reading a paper on how a commercial hatchery does it, it's not by any means impossible, but it is probably tricky. Lots of space and high light so the larvae can settle, then a way to get zooxanthellae into the babies - but the method described is to blenderize an adult and inoculate the water with it... so there's considerable investment.

The basics are that it takes a while to get spawning age clams, then getting their larva to survive is not so bad without pumps, but the initial settling requires some phytoplankton, a source of zooxanthellae for their mantles, and a lot of light (typically shallow waters in partly shaded full tropical sun). I think it's not overly challenging to do, but it may be very difficult to make a small scale experiment work out well.
 

IF YOU HAD TO OPERATE EVERYTHING ELSE MANUALLY, WHICH AUTOMATED SYSTEM WOULD YOU KEEP?

  • Auto top-off

    Votes: 62 57.4%
  • Automated dosing

    Votes: 7 6.5%
  • Mechanical filtration / roller filter

    Votes: 4 3.7%
  • Automated water testing

    Votes: 3 2.8%
  • Automatic feeding

    Votes: 1 0.9%
  • Lighting schedule

    Votes: 21 19.4%
  • Controller and remote monitoring

    Votes: 4 3.7%
  • Leak detection and emergency shutoff

    Votes: 2 1.9%
  • Automatic water changes

    Votes: 3 2.8%
  • None. I prefer to operate everything manually

    Votes: 0 0.0%
  • Something else (explain in the comments)

    Votes: 1 0.9%
Back
Top
Home
Post thread…
Market
What's new