Help with New quantum nyos 120

  • Thread starter Thread starter g5flier
  • Start date Start date
  • Tagged users Tagged users None

g5flier

Active Member
View Badges
Joined
Jan 13, 2017
Messages
264
Reaction score
245
What state or country do you live in
Georgia
Rating - 0%
0   0   0
I have a brand new system, 2 weeks old. Trying to set up a brand new Nyos 120 skimmer. I have a Nyos 160 on another system so know my way around these skimmers. However, I can't seem to stop the large amount of micro bubbles that is coming out of the lower exhaust pipe, closing the main valve dial limits the micro bubbles but then my skimmer overflows from the top, as I open the valve it to get it to stop overflowing, the skimmer increases the micro bubbles. Its been doing this now for a week, trying to get it broken in. Any suggestions? A bath in Vinegar help any?
 
Since Sunday I've been running the skimmer in bucket with 8.0" deep of RODI water and Vinegar to help it break in. Its back in the sump now at the recommended depth of 8.0 inches, the main water level adjustment knob is set to full OPEN and the water level control tube is also fully open. Doing this gets the water level as low as it can go. Despite this, the skimmer is still in full overflow mode and tons of micro bubbles are escaping out the bottom of the water level control area full bore. My tank is filled with micro-bubbles. My Nyos 160 did this for maybe 1-2 days but this 120 is now 10 days into the break in period and still doing it. Do you still think its simply breaking in?

IMG_3496.JPG


IMG_3495.JPG
 
I would have thought cleaning it in vinegar would have reset the break in period.

I thoroughly cleaned my Reef Octopus Classic in September with vinegar and it did exactly what you are describing here. I put some filter foam between the chambers to help baffle the micro bubbles and left it alone.

After about a week or two it was perfect again skimming nicely with no micro bubbles.
 
You can try raising the skimmer up or lowering the water level (if your sump has adjustable baffles).

Did you add any additives to the tank, like bacteria? I know if you use too much bacteria, like bloom conditions, it will overflow. If that's the case then you just have to run a drain tube from the skimmer to a 5 gallon bucket until it filters it out.

Some skimmers can take up to 4 weeks to break in, though the vinegar should've helped that along.
 
I would have thought cleaning it in vinegar would have reset the break in period.

I thoroughly cleaned my Reef Octopus Classic in September with vinegar and it did exactly what you are describing here. I put some filter foam between the chambers to help baffle the micro bubbles and left it alone.

After about a week or two it was perfect again skimming nicely with no micro bubbles.
Thanks, looks like I will have to wait this out!
 
I finally caved and raised the height of the skimmer so its in 6.25" of water...guess what? Working fine now. The manual says 8.0 (21cm). Shame on me, I should have known better.
 
Sorry I forgot I did the same and raised mine probably by a similar amount. I ended up lowering it back down after a week or so when it started to perform better. You might find you do the same thing.
 
Sorry I forgot I did the same and raised mine probably by a similar amount. I ended up lowering it back down after a week or so when it started to perform better. You might find you do the same thing.
Thanks, I really should have known better, I’ve had the 160 on another system for close to a year and now recall I did the same thing. That one is now in close to 11 inches of water, but was in about 7 during break-in.
 
Thanks, I really should have known better, I’ve had the 160 on another system for close to a year and now recall I did the same thing. That one is now in close to 11 inches of water, but was in about 7 during break-in.

Hi, I just cleaned my Nyos 120 thoroughly after having it run for a year in my sump. Now it is blowing microbubbles everywhere again just like in the beginning. I am gonna try and raise it a bit to see if that helps. I measured its depth before taking it out to clean and it was only in 19cm of water. I guess that a deep cleanse also causes a skimmer to have to break in again.
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 19 27.9%
  • I’d trust someone who knows my tank to choose

    Votes: 2 2.9%
  • I’d rather get a gift card and pick it myself

    Votes: 26 38.2%
  • I’d prefer gear or supplies instead

    Votes: 2 2.9%
  • Please don’t surprise me with livestock

    Votes: 19 27.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new