My IceCap 3K Gyre freezes up and stops spinning after a few minutes if I use zero percent
in my program. I have cleaned this pump with no improvement. Is there any solution besides
to never use a 0% in the program? I like running the pump from 0% up to 20% then to 0%
Any suggestion?
Here is a video that might show this better
Thank you
Steve
in my program. I have cleaned this pump with no improvement. Is there any solution besides
to never use a 0% in the program? I like running the pump from 0% up to 20% then to 0%
Any suggestion?
Here is a video that might show this better
Thank you
Steve