IceCap Co2 scrubber installation

  • Thread starter Thread starter iamacat
  • Start date Start date
  • Tagged users Tagged users None
i have a 3/8 tube but it just slides right onto the scrubber inlet. Does it need to be an air tight connection?
 
i have a 3/8 tube but it just slides right onto the scrubber inlet. Does it need to be an air tight connection?
It will suck air in from the path of least resistance. If the tube is a snug fit almost the diameter of the inlet then most likely it will be fine. But if the tube is smaller diameter and there is obvious room around the tubing for air to get in then you have a problem that would need to be addressed.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new