If you were starting from scratch.......

  • Thread starter Thread starter PedroYoung
  • Start date Start date
  • Tagged users Tagged users None

PedroYoung

Valuable Member
View Badges
Joined
Feb 12, 2014
Messages
2,082
Reaction score
2,777
Location
Chelsea, AL
Rating - 0%
0   0   0
So I am in a unique position. I am rebuilding my house after a fire (total loss) and am going to move my sump to the basement under the 180g diplsay tank. If you were in my situation what would you "have to have" that you don't have now (not equipment, but architectural details)? I am putting a drain under the sump, having a sink and water line run for RO, and a couple dedicated circuits run for power. What else should I be planning for? I am trying to at least get something positive out of this ordeal.
Thanks for your input.
 
I think the biggest impact to consider would be ways of preventing buildup in the sandbed if applicable

not that sandbeds are bad, i have one very deep its just cleaned often enough so as not to foul, and whether or not it imparts any gas benefits doesnt matter because nitrate is dealt with in other ways. but for a large tank if I was doing over, id consider making any type of approach vs the standard hands off, ever increasing in mass dsb. so many variations can be ran that make them not a diaper. I prefer sandbeds for the look not function
 
Space for fresh and salt water vats for the ever important water changes. Depending on budget a small temporary tank to treat all incoming corals for possible predators. Then to make the wife crazy a frag tank and wet saw.....
 
If the sump is going to be in the basement like you stated above and you only want "architectural" recommendations, ventilation both in and out.
Think of it like a bathroom, you'll want to pull humidity out, but also CO2 exhausted by the gas exchange and bring in clean dehumidified air.

You might already have this covered but insulation, to aid in keeping it warm in the winter and cool in the summer.
 
Last edited:
I think you hit the things I would look at adding, drain, large sink (with a disposal) and circuits. Also sorry to hear about the house. If my house had to be rebuilt I'd also add in a tankless water heater since you can add the ventilation easy....not fish related :)
 
Generac (or similar) for power failures.
Extra bracing under the tank.

And as stated above... drains, sink, heating/cooling, dehumidifier, and more than just "a couple" dedicated circuits. Minimum of 4. Definitely go with more than you think you'll need.
I would also epoxy coat the floor, using a commercial installer.
 
Great feedback everyone. Please keep them coming. I had been thinking about the ventilation problem, will be sharing the basement with storage and other stuff so don't want mildew. At this point it's pretty cheap to add electrical circuits, as long as I don't fill up the 2 breaker boxes in the budget. Hadn't thought about epoxy coating the floor, sounds like worth looking into (was going with sealed concrete).
 

IF YOU HAD TO OPERATE EVERYTHING ELSE MANUALLY, WHICH AUTOMATED SYSTEM WOULD YOU KEEP?

  • Auto top-off

    Votes: 45 57.7%
  • Automated dosing

    Votes: 5 6.4%
  • Mechanical filtration / roller filter

    Votes: 4 5.1%
  • Automated water testing

    Votes: 3 3.8%
  • Automatic feeding

    Votes: 1 1.3%
  • Lighting schedule

    Votes: 13 16.7%
  • Controller and remote monitoring

    Votes: 3 3.8%
  • Leak detection and emergency shutoff

    Votes: 1 1.3%
  • Automatic water changes

    Votes: 2 2.6%
  • None. I prefer to operate everything manually

    Votes: 0 0.0%
  • Something else (explain in the comments)

    Votes: 1 1.3%
Back
Top
Home
Post thread…
Market
What's new