Jebao dmp-10 Master/Slave help needed.

[SomeHappyFish]

I do not get it. I made a schedule on pump one and selected Master then on the other one I selected Slave but it always turns on Constant Mode at the selected %. How do I switch it to my custom schedule to have a matching pulse or cross flow?

 

[SomeHappyFish]

Bluetooth version.

 

[chello]

I do not get it. I made a schedule on pump one and selected Master then on the other one I selected Slave but it always turns on Constant Mode at the selected %. How do I switch it to my custom schedule to have a matching pulse or cross flow?

Hello!
Sorry, I won’t be able to help on your question..
Nevettheless, I’m about to buy a dmp-15, but I can’t find anywhere any info about the size of the dry side unit. (My tank is very close to the wall on the side where it would be placed, and I’m not sure if it fits there..)
Not even the jebao store’s customer service could give me that info on aliexpress..
so I know, it’s probably somewhat snaller, but could you please measure it for me on your dmp-10?

 

[SomeHappyFish]

The dry side unit sticks out 2 inches and 1/4. :)

 

[Idech]

I don’t use the app and my slave/master are okay even if they are not the same pump model. I don’t remember if I have a schedule though but I have night mode on.

 

[reefpanda]

Did you select the settings you want before setting it to slave on the slave unit?

 

[Jonreefer]

I do not get it. I made a schedule on pump one and selected Master then on the other one I selected Slave but it always turns on Constant Mode at the selected %. How do I switch it to my custom schedule to have a matching pulse or cross flow?

Select linkage then master, then select program. Setup the program fully how you want it to run.
Then go to the slave pump and select it as slave and set the max speed the flow you want out of it. It should work properly then.
If you make a schedule under the program tab and then select slave on the other they wont talk.
You have the click the linkage on the master and then pick program and then go over and select the salve.

 

[SomeHappyFish]

Did you select the settings you want before setting it to slave on the slave unit?

Yes

 

[SomeHappyFish]

Select linkage then master, then select program. Setup the program fully how you want it to run.
Then go to the slave pump and select it as slave and set the max speed the flow you want out of it. It should work properly then.
If you make a schedule under the program tab and then select slave on the other they wont talk.
You have the click the linkage on the master and then pick program and then go over and select the salve.

Already tried :/

 

[Idech]

I do not get it. I made a schedule on pump one and selected Master then on the other one I selected Slave but it always turns on Constant Mode at the selected %. How do I switch it to my custom schedule to have a matching pulse or cross flow?

Once mine wouldn’t go in slave mode so I just unplugged it for a minute and replugged it. Maybe try that.

 

[SomeHappyFish]

Once mine wouldn’t go in slave mode so I just unplugged it for a minute and replugged it. Maybe try that.

Tried it also. I can make it work into Master/Slave but not with my own program

 

[M@rine Lover]

Tried it also. I can make it work into Master/Slave but not with my own program

Any update? I have the same problem

 

[SomeHappyFish]

No sorry I tried :(