Klir filter 4 inch installation

[Tim_CO]

So little update on the klir after not having any instructions I wasted 3 rolls of this fleece. Coralvue Carlos told me I installed it wrong. I was having the sensor installed to close to water fluctuation. Having it fixed and finally getting the power y cable for running two at a time. This thing's working great. Only time will tell how long the motor lasts as the roll of wet fleece does out some stress when rolling up all wet.

Hey scuzy - Thanks for the directions here on making this work with the trigger 39. I'm about to do this to my Trigger Sapphire 39 with a custom 2 hole filter sock plate. I've got some questions if you don't mind:

- Per the message above, how did you have it installed wrong?
- Fabricating the 2 hole holder, did you just put the 4" holes dead center on the plate or did you have to offset them some?
- You mentioned having to get more parts to run it in master/slave. Where did you get these parts?
- Any other gotchas I should watch out for?

Thanks - Tim

 

[Abunadeez]

So little update on the klir after not having any instructions I wasted 3 rolls of this fleece. Coralvue Carlos told me I installed it wrong. I was having the sensor installed to close to water fluctuation. Having it fixed and finally getting the power y cable for running two at a time. This thing's working great. Only time will tell how long the motor lasts as the roll of wet fleece does out some stress when rolling up all wet.

Can you show a pic of the right way to set it up ?