On the adapters, yeah, I had custom ones made for the Radions, as long as there are 4 screw holes on the top side and the foot print is the same or smaller, I can get it in my rack. Sounds like I need to do a little more hole work. Where would you start reading up on these more so?
They do have 4 holes on the back, and you can probably speak with Daniel about the adapters - he can likely print custom ones for you.
One thing I would put an extra caution on is the power connector sticking on the back side, you should count it when measuring its full foot print (it’s the same with the Radion, but figured I would mention it anyway).
As far as where to start - I would read the spec on the site and do quick review on it on the forums. Than contact Daniel for more specific questions like its foot print and the adapters.
can you post your settings?
Of course, I will share them later today.
How do you connect them together? Are they daisy chained?
Depends what you mean by connecting them together.
Grouping is done automagically and you can separate them into different groups.
Each group keeps the lights in it in sync.
I for example have 5 groups:
1. Main Tank Uno 1
2. Main Tank Uno 2.X
3. Main Tank Sump (frag section)
4. Frag Tank
5. Temporary coral QT/frag tank
If you’re asking about power - you can power 2 fixtures with a single power supply by using a Y splitter.
But note that not every Y splitter would work, it needs to support the high amperage - the ones he sells on his site are obviously rated appropriately.
I’ve never tried this feature myself, but the Y splitters aren’t too expansive to give it a try if it works for you in terms of wiring.