I had a complete P4 system on the tank I just took down that included 2 of the 6E power bars, and 1 6 power bar. I am upgrading to a larger tank and I was needing 8 additional switchable sockets to turn on 8 sets of T5 bulbs (non-dimmable) so instead of buying 2 more 6E powerbars with 12 outlets, I bought 2 STDL4-4 powerbars which gave me 8 sockets.
I got the 2 new power bars in and before I shut down the old tank, I plugged them into the P4 and they powered up and were switching on and off like they were supposed to. I still had the 6Es connected when I did, so there were actually 2 channel 1s, 2 channel 2s etc. because I hadnt reassigned the 6E outlets at the time but the STDL4-4s were switching like they were supposed to.
I got the old tank taken down and I have been getting everything configured on the GHL including reassigning socket numbers. I got all of the 6 and 6E sockets reassigned 9-26 and I had planned for the 2 STDL4s to be sockets 1-4 and 5-8. I got every thing connected and the STL4-4s do nothing as far as commands. I have been reading the manual and the programming guide and I cant seem to figure this out. What am I missing?
I got the 2 new power bars in and before I shut down the old tank, I plugged them into the P4 and they powered up and were switching on and off like they were supposed to. I still had the 6Es connected when I did, so there were actually 2 channel 1s, 2 channel 2s etc. because I hadnt reassigned the 6E outlets at the time but the STDL4-4s were switching like they were supposed to.
I got the old tank taken down and I have been getting everything configured on the GHL including reassigning socket numbers. I got all of the 6 and 6E sockets reassigned 9-26 and I had planned for the 2 STDL4s to be sockets 1-4 and 5-8. I got every thing connected and the STL4-4s do nothing as far as commands. I have been reading the manual and the programming guide and I cant seem to figure this out. What am I missing?