Need help with flow!!!

[Wonkabar]

I have 4 pm 40s and two reef wave 25 gyres. I want to keep as much as possible off of the 3 visible sides of the tank. What do you think is the best way to get good random flow for sps? Where should I place what?

 

[tbrown]

A lot of the gyres have flow diverters that can aim the flow across instead of straight out. I'd maybe do the gyres on the back glass 1 on each end, with diverters aiming down the back and then the mp40s towards the back of the sides - 1 towards the top, 1 towards the middle.

After that, I'd fire them up and adjust flow and position as needed to avoid constant sand storms.

 

[tbrown]

 

[X-37B]

I have 4 pm 40s and two reef wave 25 gyres. I want to keep as much as possible off of the 3 visible sides of the tank. What do you think is the best way to get good random flow for sps? Where should I place what?

Sell 2 mp40's and the gyers.
Place 2 mp40's on the back wall.
Put a Sea Sweep on each end with a Tunze 6255. All the random flow you will ever need and the cord goes through the sweeps.
I run 2 of said in my 60×30×22 and need nothing else with plenty of power to spair when the system grows in.
The 2 40's on the back will help with the high rock scape.
Anyway something to think about.

 

[Wonkabar]

Sell 2 mp40's and the gyers.
Place 2 mp40's on the back wall.
Put a Sea Sweep on each end with a Tunze 6255. All the random flow you will ever need and the cord goes through the sweeps.
I run 2 of said in my 60×30×22 and need nothing else with plenty of power to spair when the system grows in.
The 2 40's on the back will help with the high rock scape.
Anyway something to think about.

I have thought extensively about just this