Neptune Systems LLS mount for 55g Drum

Sisterlimonpot

Effortless Perfection
View Badges
Joined
Jul 15, 2009
Messages
4,905
Reaction score
8,642
Location
Litchfield Park
Rating - 100%
2   0   0
I was given a 15" LLS when they were still being tested, and I put it in my sump to monitor the level of evaporation. I was intrigued with all the possibilities of knowing exactly the level of the water, that I started thinking about how I can use these for my 55g bins for fresh and salt water.

However these blue barrels aren't quite 35" but definitely longer than 23".

I ended up getting 2 of the 35" ones and figured I'd probably just cut a hole in the lid to allow them to stick out.

That idea changed once I got them and discovered I can set them in the bins at an angle and still have the lid close down over them.

So I set out to take some measurements and utilized some geometry to design what's probably an overcomplicated mount.

Here it is in a nutshell it's a 6 piece print, 2 pieces are grey PLA, 3 are black PETG and the washer is black TPU.

20230104_195200.jpg




20230105_152225.jpg


20230104_195731.jpg


20230104_195743.jpg


I printed 2 sets for each barrel and after getting them in, I decided that the washer should encompass the entire part so I did a little redesign and here it is finished and ready to be programmed.

Screenshot_20230108_163427_Gallery.jpg
 
I was given a 15" LLS when they were still being tested, and I put it in my sump to monitor the level of evaporation. I was intrigued with all the possibilities of knowing exactly the level of the water, that I started thinking about how I can use these for my 55g bins for fresh and salt water.

However these blue barrels aren't quite 35" but definitely longer than 23".

I ended up getting 2 of the 35" ones and figured I'd probably just cut a hole in the lid to allow them to stick out.

That idea changed once I got them and discovered I can set them in the bins at an angle and still have the lid close down over them.

So I set out to take some measurements and utilized some geometry to design what's probably an overcomplicated mount.

Here it is in a nutshell it's a 6 piece print, 2 pieces are grey PLA, 3 are black PETG and the washer is black TPU.

20230104_195200.jpg




20230105_152225.jpg


20230104_195731.jpg


20230104_195743.jpg


I printed 2 sets for each barrel and after getting them in, I decided that the washer should encompass the entire part so I did a little redesign and here it is finished and ready to be programmed.

Screenshot_20230108_163427_Gallery.jpg

Awesome. I am in need of one for a sump with eurobracing

1673224368202.png
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 22 26.5%
  • I’d trust someone who knows my tank to choose

    Votes: 8 9.6%
  • I’d rather get a gift card and pick it myself

    Votes: 30 36.1%
  • I’d prefer gear or supplies instead

    Votes: 2 2.4%
  • Please don’t surprise me with livestock

    Votes: 21 25.3%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new