Panworld ps200 fitting

Catchemall

Well-Known Member
View Badges
Joined
Jun 11, 2015
Messages
808
Reaction score
527
Rating - 0%
0   0   0
I have a panworld 200ps return pump. I can’t seem to find a female npt fitting that fits this thing. The pump came with 1” npt male threads. Am I missing something. The female fitting I have will only got a couple turns and locks up.
image.jpg
 
Anyone have any insight they could share. Anyone have one of these pumps that could guide me on the right direction?
 
All the pan world pump’s I’ve had in the past had imperial fittings. I do seem to recall a pretty tight fit on the threads, but it’s been quite a few years..

Is this pump new or used? Particularly if it’s not been used before, you might inspect the male threads for casting lines interfering. Also keep in mind that teflon tape or thread sealant will lubricate a bit and may allow it to thread together better.
 
All the pan world pump’s I’ve had in the past had imperial fittings. I do seem to recall a pretty tight fit on the threads, but it’s been quite a few years..

Is this pump new or used? Particularly if it’s not been used before, you might inspect the male threads for casting lines interfering. Also keep in mind that teflon tape or thread sealant will lubricate a bit and may allow it to thread together better.
It’s new. I gotta find a tapered female thread I guess.
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new