PL descriptions deleted since updating

[Kyle Sicard]

Anyone else having issues with your descriptions being deleted for your programming logic after updating to the newest firmware? I made some new descriptions after updating and then when I was configuring my new float sensors I checked back and those got deleted again. Never had this issue till I updated earlier today.

 

[reefwiser]

Did you back your Profilux settings before updating?

 

[Kyle Sicard]

I did, but I have since programmed all my float valves into my PL and what not and would rather not have to repeat that. Especially with any new changes sometimes deleting the descriptions again. Fortunately since I made that PL tips and tricks thread I can just look over that to find the descriptions.

I more so wanted to check and see if any other users are experiencing the same issue. I do not plan to rewrite all the descriptions until I'm sure they wont be deleted again.