Robo Tank - power strip not working after power surge

[k2-]

Well, i connected one of my machines (Ryobi saw) to the Robo tank power strip, and power surge and - boom - since then strip has stopped working.

Any suggestion on a fix or is it a goner?

 

[Dom]

Well, i connected one of my machines (Ryobi saw) to the Robo tank power strip, and power surge and - boom - since then strip has stopped working.

Any suggestion on a fix or is it a goner?

There's probably a reset button. Decent strips have a built in breaker.

 

[Ranjib]

If I recall correctly, there’s a fuse inside, likely that’s tripped, you should be able to replace it a new one. But, I’m not 100% sure, . I’m not using one, I’ll let @robsworld78 confirm,

 

[robsworld78]

Well, i connected one of my machines (Ryobi saw) to the Robo tank power strip, and power surge and - boom - since then strip has stopped working.

Any suggestion on a fix or is it a goner?

There is a fuse inside that likely blow, it's 10 amps. If you remove the lid and look near the main AC input you'll see it. The fuse size is 5mm x 20mm.

 

[juniorgomez708]

Hey question since you have the power strip. Are you able to monitor whatever is connected to it on your phone?

 

[k2-]

I can monitor but only when I am connected to the same network as my reef-pi is connected. its not cloud-enabled.

 

[ColoredRock]

I can monitor but only when I am connected to the same network as my reef-pi is connected. its not cloud-enabled.

Not cloud enabled .. but that is a good thing IMHO.. need be set up a VPN to tunnel thru again if you need too.

 

[ColoredRock]

Hey question since you have the power strip. Are you able to monitor whatever is connected to it on your phone?

Azure or AWS cost $$.. only solution (maybe im wrong).. but that is really the only way to make stuff on the cloud.