Rodi and booster questions

[KStatefan]

Verify everything is hooked up according to the instructions.

Can you post pictures of it?

 

[Hannah2024]

Verify everything is hooked up according to the instructions.

Can you post pictures of it?

Yes here I know the colors are different but I took a video to show

 

[KStatefan]

It is hard for me to follow the video but it looks like the gauge in on the inlet side of the booster you would want it on the outside of the pump.

 

[Hannah2024]

It is hard for me to follow the video but it looks like the gauge in on the inlet side of the booster you would want it on the outside of the pump.

Do you think you could circle the spot it would have to go if I sent a picture of the whole thing

 

[KStatefan]

Remove it from here

Put it here

 

[Hannah2024]

Remove it from here

Put it here

Ok I actually have another question- how do I take it off and the red tubes have two sides is there a way to like plug it up or move that?

 

[KStatefan]

Unplug the red line from the carbon filter. Unplug the yellow line from the y fitting. Plug the yellow line into the carbon filter.

Move the y fitting to to membrane inlet. Run a line from the y fitting to the gauge.

 

[Hannah2024]

Unplug the red line from the carbon filter. Unplug the yellow line from the y fitting. Plug the yellow line into the carbon filter.

Move the y fitting to to membrane inlet. Run a line from the y fitting to the gauge.

Ok I’m not home yet but when I am I will do that

 

[Hannah2024]

Unplug the red line from the carbon filter. Unplug the yellow line from the y fitting. Plug the yellow line into the carbon filter.

Move the y fitting to to membrane inlet. Run a line from the y fitting to the gauge.

Thanks a lot just did it now it’s at about 90 psi

 

[KStatefan]

Thanks a lot just did it now it’s at about 90 psi

That should get the membrane working good.