So I bought a TDS module along with a pressure gauge and new filters for the entire Rodi system that I got used. I just turned it on flushed it for about 10 minutes then turned the valve to produce Rodi water.
Canister 1 has the floss filter. Canister 2 has the block charcoal and canister 3 has the DI resin.
I have sensor one hooked up to the water of my faucet.
Sensor number two is right before it goes to the RO membrane.
Sensor 3 is the output after the Di canister.
On the monitor sensor one is running 209 from my tap water. Sensor number 2 is running a lot higher than that. And the output of my entire system is running at 4.
Is this normal with brand new filters? Or am I doing something wrong?
Tap water
Reading before going through Ro membrane
Finished product.
So is this normal with a new filter system? Or something severely wrong?
Canister 1 has the floss filter. Canister 2 has the block charcoal and canister 3 has the DI resin.
I have sensor one hooked up to the water of my faucet.
Sensor number two is right before it goes to the RO membrane.
Sensor 3 is the output after the Di canister.
On the monitor sensor one is running 209 from my tap water. Sensor number 2 is running a lot higher than that. And the output of my entire system is running at 4.
Is this normal with brand new filters? Or am I doing something wrong?
Tap water
Reading before going through Ro membrane
Finished product.
So is this normal with a new filter system? Or something severely wrong?