RODI - reading 0.1 tds

  • Thread starter Thread starter Ky_acc
  • Start date Start date
  • Tagged users Tagged users None

Ky_acc

Active Member
View Badges
Joined
Jun 16, 2019
Messages
294
Reaction score
125
Rating - 0%
0   0   0
Hi folks, just a quick question.

I just got a new RODI unit from @Buckeye Hydro (great unit!). I let it run to flush the system and then I produced and discarded the first gallon of RODI water.

after that I produced ~5 gallons of fresh RODI water and tested it using my HM Com 100 HM Com 100 and it is reading 0.1 tds.

I am wondering whether that 0.1 reading is within margin of error or if I need to troubleshoot what is causing a trace tds reading?

thank you!
 
Accuracy: +/- 2%
 
How did you test the product water? Was it in the container or did you do it separately? I usually do mine in a separate cup that I have cleaned before hand. Have you had the tds meter tested against a known solution?
 
Yes I tested the tds meter against the HM 342ppm solution, it was pretty much spot on

I also pulled the water out into a clean glass that I rinsed with RODI prior to testing
 

TOP 10 Trending Threads

WHAT DO YOU ALWAYS RUN OUT OF AT THE WORST TIME?

  • Salt mix

    Votes: 17 18.7%
  • Fish or coral food

    Votes: 5 5.5%
  • Test kits or reagents

    Votes: 9 9.9%
  • Filter media or replacement fleece

    Votes: 5 5.5%
  • RO/DI filters or supplies

    Votes: 14 15.4%
  • Fragging and repair supplies, like glue or epoxy

    Votes: 10 11.0%
  • I keep a backup of everything

    Votes: 24 26.4%
  • Other (Post in the comments)

    Votes: 7 7.7%
Back
Top
Home
Post thread…
Market
What's new