Who knows, can't hurt, might even help.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Fully submerged worked fine - the top of it is about 1" under water.for the 45 degree cut , is the entire 45 degree angle submerged or is the short side of the cut out of water?
I did the secondary siphon about 3/4" above the primary and for the emergency I made sure was above the secondary. Tank dimensions are a 65 rimless 36" length by 20" front to backdid I just hear a pin drop? what size DT and do you know your durso pipe heights in your box?
I just left it off because I didn't want it to fall into the tank while doing a test run and making adjustments. I can measure the primary pipe tommorow if you'd like. I would say it's probably an inch. But I can measure it for youIs there a reason the weir is not attached on the inside of the tank?
dang it! I should've checked the bulkheads before I started glueing. dang it dang it!Here is a pic of what I have. Nice and simple !
reasoning?I ordered Slip x Thread bulkheads from BRS. Want to thread in to the dry side.
this makes me feel better. My fiance just yelled out, "y'all both probably didn't read the instructions!" (guilty)You're not alone. See my build thread - same mistake. They ship that way to save space I think. But makes perfect sense to flip them and even the instructions show them the correct way. I'm kicking myself too!