Hello,
I am planning on building the water mixing station as depicted below.
Before beginning, I thought I'd see if the experienced and brilliant minds on here have thoughts/suggestions.
NOTE:
- By closing/opening the appropriate ball valves, the pump will either circulate the salt between the middle and low containers OR push the mixed saltwater directly to the DT.
- The RO/DI will have separate lines to the uppermost container and the auto top off bin under the DT (both with an auto-shutoff).
I have yet to finalize the "best" way to remove the water from the DT during a water change / sand siphoning...
THANKS in advance
(I already have 6 of these bins on casters that I've been using, otherwise I'd buy two big storage containers and have a much simpler setup)
I am planning on building the water mixing station as depicted below.
Before beginning, I thought I'd see if the experienced and brilliant minds on here have thoughts/suggestions.
NOTE:
- By closing/opening the appropriate ball valves, the pump will either circulate the salt between the middle and low containers OR push the mixed saltwater directly to the DT.
- The RO/DI will have separate lines to the uppermost container and the auto top off bin under the DT (both with an auto-shutoff).
I have yet to finalize the "best" way to remove the water from the DT during a water change / sand siphoning...
THANKS in advance
(I already have 6 of these bins on casters that I've been using, otherwise I'd buy two big storage containers and have a much simpler setup)