Ok ok, here we go... kinda... I've ordered the waterbox 130.4 April 9th and after it was lost in transit, then found, and finally delivered to me. Luckily it was delivered in phenomenal shape. Lucky me. Now I have some equipment that I have purchased over the last couple months that have sat.
Tunze stream 6095's
Cor-20 return pump
Bubble magus curbe 7 elite version
2 eheim jager 250w heaters.
Mixing station with pan world 100px-x
Now you will see my tank is missing the doors. That is because I could not for the life of me line them u . One has a slight warp. The gap on the outside is horrible. And then bottom corner sticks out it was ticking me off. I closed the hinges as far as they can go and it's still a huge gap due to the warp. On the other side it actually fit well except when I had the ms. Hold it up level to the top of the cabinet. I tightened it and the top corner away from hinges would drop slightly. I could not for the life of me get it to be straight. So me getting frustrated and sweating I said I'm going to just try to bend it u . And yup! Snapped the hinges right out of the inside of the cabine . So im working on finding a solution and fixing that. The dam doors are so heavy. I might go buy 6 blum soft close doors and install those and see if they hold the heavy door better without sag. Which will use different holes and I'll have to patch the ripped out molly holes.
They say it's real wood but its furniture plywood.
I'm also wondering quality blum hinges might force the slight warp to get closer to the cabinet.
Tunze stream 6095's
Cor-20 return pump
Bubble magus curbe 7 elite version
2 eheim jager 250w heaters.
Mixing station with pan world 100px-x
Now you will see my tank is missing the doors. That is because I could not for the life of me line them u . One has a slight warp. The gap on the outside is horrible. And then bottom corner sticks out it was ticking me off. I closed the hinges as far as they can go and it's still a huge gap due to the warp. On the other side it actually fit well except when I had the ms. Hold it up level to the top of the cabinet. I tightened it and the top corner away from hinges would drop slightly. I could not for the life of me get it to be straight. So me getting frustrated and sweating I said I'm going to just try to bend it u . And yup! Snapped the hinges right out of the inside of the cabine . So im working on finding a solution and fixing that. The dam doors are so heavy. I might go buy 6 blum soft close doors and install those and see if they hold the heavy door better without sag. Which will use different holes and I'll have to patch the ripped out molly holes.
They say it's real wood but its furniture plywood.
I'm also wondering quality blum hinges might force the slight warp to get closer to the cabinet.