Brew12
Electrical Gru
View BadgesExcellence Award
Reef Tank 365
Article Contributor
Moderator Emeritus
North Alabama Reef Club
Article Administrator
My Tank Thread
I wouldn't recommend doing that. It would be acceptable to do per the NEC if you made the splice in a properly listed enclosure. It may not be per code based on your local codes. I would either cut back the old cable and run it intact to the location you wanted the new receptacle or run an entire new cable from your breaker panel to the receptacle location.Can I safely 'tap' into the 220v line in the attic and run it over to my garage? If so, do I need to change my compressor over to a 3 pin plug to make this an easier/safer installation?
I would then match the receptacle to what the air compressor is designed to use.