bulkheads

As pictured WYSIWYG Lots of parts, many bulkheads, three 1.5" clear swing check valves, pvc fittings, black and grey, screens, most 1.5" slip fittings, plus much more!

I am setting up a used 120g, it is a 2 overflow system, and i replaced 2/4 bulkheads. the bulkheads I replaced where both damaged, however the other two seemed good. When I water tested the bulkheads that were old (return pump bulkheads) they both ended up leaking/dripping (slowly). I have...

I see that it’s common to use ABS bulkheads for the overflow of an aquarium. What do people use to connect PVC pipe to an ABS bulkhead? I’ve got a new 120 gallon acrylic aquarium with an internal overflow with holes in the bottom for overflow and return plumbing. It came with what I believe are...

I have a tank with 37mm (1-7/16") and 30mm (just under 1-3/16") holes. I can't seem to find metric bulkheads, and I'm wondering if I can use the next size down in imperial sized bulkheads without issue. Any advice would be appreciated!

so I recently acquired an aqua top reef3 cube. It was supposed to be a full setup plumbing included but long story short I only got the tank. It came drilled and I'm having trouble figuring out what size bulk heads to order because the hole drilled for the return is less than an inch in...

Hey all, Setting up an innovative marine INT 75 and just hard plumbed to the sump ( icecap 30) . Ifilled with fresh water to leak test and everything’s working as intended but the drain bulkheads all have a very slight leak. they’re hand tightened very snug. Should I attempt to snug...

Clownfish

Hi all, New member here. I just upgraded by 20 gallon nano to a 50 gallon cube. I just finished the plumbing for my sump recently and instead of slipxslip bulkheads I used 1" bulkhead abs slip×thread for the ability to replace in the future if needed. I used 1" schedule 80 male pipe adapters...

So I'm in the stage of plumbing my 180 RR tank. On my current 93 cube I have the standard bulkhead attached to a pvc adapter for a barbed connection. I found online, bulkheads that are barbed on the bottom. Is this basically the same thing, does it put more pressure on the actual bulkhead, or is...