Apex fusion and mp40

[seeky007]

Hi
I have a apex jr and a vortech mp40 connected using the mxm module I go in to the settings for flow set my desired daily flow upload it to the apex go to dash bord turn it on and it just goes to %100 no matter what I do so for thetime being I have switch back to using mobius any idea what I'm doing wrong?

 

[boacvh]

Struggled with the same. Try setting it to auto, not on, that's how I did it on mine. On will make it 100%

 

[seeky007]

Struggled with the same. Try setting it to auto, not on, that's how I did it on mine. On will make it 100%

So if I set it to auto and set up my flow within fusion that should be ok.and have the mobious as fall back flow setting?

 

[Sisterlimonpot]

Auto is the only setting that will follow the program you set for it.

On and off are just that. Full on and completely off.

There is a slight learning curve to understand apex fusion.

They have a decent tutorial that sets you on the right track.

 

[seeky007]

Auto is the only setting that will follow the program you set for it.

On and off are just that. Full on and completely off.

Thank you

 

[Sisterlimonpot]

Thank you

As for your fallback question. I usually set the vortech fallback the same as what's set in fusion. That way if there is a communication issue with mxm the vortech won't skip a beat. The only downside is that you won't be able to have remote access to your mxm controlled devices until you fix the communication issue... which is usually a simple power cycle.

 

[seeky007]

As for your fallback question. I usually set the vortech fallback the same as what's set in fusion. That way if there is a communication issue with mxm the vortech won't skip a beat. The only downside is that you won't be able to have remote access to your mxm controlled devices until you fix the communication issue... which is usually a simple power cycle.

Thanks for that I will try it out later.