Can someone make CP-90 Bracket for me.

[Espino963]

Hi Everyone,

I'm hoping someone could make this bracket for my Jebao CP-90 wavemaker. I'm located in Orange County, CA.

I would like QTY:1 (Black) If possible. I found this on the forums but not sure if it's the exact same.

Thanks in advance.

https://www.thingiverse.com/thing:2091392

 

[Shirak]

looks like it's just pushed into the bracket in the photo? No clue if the two controls are the same size but if you post a photo or two and can take accurate measurements down to 1/10th mm then shouldn't be hard to make something.