DIY Diatom Filter for under $100.00

  • Thread starter Thread starter Paul B
  • Start date Start date
  • Tagged users Tagged users None
Just ordered everything I need for your cleaner. Was looking through your book about Aquariums I want to start a new tank Third. Do you have more detailed photos of your gravel filter? Maybe a source for the substrate needed?
Who are you asking?

I go for an hour walk every morning, rain, shine, snow or ice in the dark before sunrise . I am going in a few minutes. It's my exercise and therapy but I still can't sleep at all. :confused:
 
Who are you asking?

I go for an hour walk every morning, rain, shine, snow or ice in the dark before sunrise . I am going in a few minutes. It's my exercise and therapy but I still can't sleep at all. :confused:
You. I wondered if you had a more detailed drawing or photo of your reverse under gravel filter
 
Being it's under the gravel, I don't have a picture, but this is my old manifold that sat above the water on one side of the tank. I built a new one now but it's basically the same thing. Water is pumped into it from a powerhead which I have behind the rocks. It gets about 600 GPH so about 150 or so GPH down each of the three tubes which are bend in the back, bottom of the tank to get to the 3 UG plates.

Any clear plastic container will do, here I used an old HOB filter box.

No faster or it will collect to much detritus.



 
I Had quit a few things that needed to be done but today I finally put my attention to Paul's filter. It is complete with a couple of twists. One is a three way valve , and figured out an easy way to backflush. Unfortunately I knocked it on the ground and found out how easy PVC nipples break. Luckily I have an easy out, went and bought some more and got it tested for water flow, and how to prime it without putting a container in my Tank as Paul does. Tomorrow I hope to try and load the powder in it, running a 5 Micron filter, and have something in mind to mimic the internal tube like on the original may work may not, may not need to worry we will see. Then will post pictures
 
I am looking forward to it. I was also going to put that tube in but there is very little room for it so I just do it with the container in the tank. :D
 
So I took Paul’s design and modified slightly to put the pump on top of the canister. I got it running and it’s doing its thing nicely. Pulling air in from somewhere so will have to go back and reseal some of those threaded fittings. The base is a small pet bowl that I bought at the grocery store. I cut a hole in the bottom and flipped it over so the canister could slide right in. I then painted it black and super glued the seam using thick cyanoacrylate. Nice and sturdy.

Thanks so much for the idea Paul!!!

Fun build!!!

IMG_4056.jpeg IMG_4055.jpeg
 
The problem with putting the motor on top is the same problem Vortex had on their original diatom filter. A little air in the system and the pump gets airbound and stops. With the motor on the bottom, the entire thing can fill with air and it keeps going. It's also very easy to start with the motor on the bottom. :beaming-face-with-smiling-eyes:

I tried it like that but abandoned that method but I hope it works for you
 
The problem with putting the motor on top is the same problem Vortex had on their original diatom filter. A little air in the system and the pump gets airbound and stops. With the motor on the bottom, the entire thing can fill with air and it keeps going. It's also very easy to start with the motor on the bottom. :beaming-face-with-smiling-eyes:

I tried it like that but abandoned that method but I hope it works for you
Thanks for the heads up. I ran this configuration for the first time yesterday. Ran it for about 4-5 hours with the only issue being the air at the top of the canister. A little would purge out ever few seconds but air always remained. I used about a 1/2 cup of DE and it polished the water very nicely. Flow coming out remained strong for the duration. I will go back and reseal my threaded connections to see if I can limit the amount of air in the canister and report back at some point.
 
I am looking forward to it. I was also going to put that tube in but there is very little room for it so I just do it with the container in the tank. :D
I found it a bit too powerful. Almost blew a coral off its base being careless so ordered a globe valve to add on ( waiting )
 
In my test it looks like some of the diatom powder is getting through the 30 micron filter so I ordered some 5 micron filter cartridges for a test.
I knew there would be some tweeking to do.
Outstanding! The 5 micron filter is a good idea. Diatoms can be extremely small - the lower end of the range is actually 2 microns.

P.S. I used a DE (diamtomaceous earth) filter about 2 hours per week for many years and it worked great. I don't remember the brand name.
 
Hi keep trying to complete this hit two snags chime in if you are willing. First as I read the powder goes to the bottom and cakes it. Also priming the pump is a pain. I have a good plan for the priming waiting for another three way valve. The powder is another issue. I have an absolute guaranteed solution fo
1000001875.jpg
1000001870.jpg
1000001871.jpg
1000001873.jpg
1000001874.jpg
r this but I d
1000001877.jpg
on't want to do it as would run the risk of damaging the O ring of the filter container. It would be just wetting the filter and putting powder on it. I tried it and seems to be ok. However I am still going to try to put a tube to the bottom of the canister. I think I can . Failing that I wonder about using another pump and forcing it in from the inlet side then switching it over . It would be a simple connection with temporary tubes. Here is some pictures of what I have so far. The green hose connects to the sink tap, and the union for back flushing. The white container is just to get things working
 
Who are you asking?

I go for an hour walk every morning, rain, shine, snow or ice in the dark before sunrise . I am going in a few minutes. It's my exercise and therapy but I still can't sleep at all. :confused:
By the way I did not see where anyone talked about the powder itself. It is an interesting waste of time to learn about it. It actually ties int coral growth globe wide according to Wikipedia
 
What does? Diatom powder?
Yes read it on Wikipedia apparently gets blown by the winds quite far from where it originates, and goes on natural coral. On to of that the food grade stuff is used for all sorts of health benefits including gut health
 
Best place to get the canister online in the states? This has me very intrigued.
 
That was a very smart design sir! I’m sure it will work fine. You should patent it. I’d buy one. My old vortex diatom filter is somewhere packed away. I need it now to clean a large turtle tank. I’m getting back into the fish hobby soon.
 
That was a very smart design sir! I’m sure it will work fine. You should patent it.
Thank you. I use it all the time to clean up dead algae. 😎
I already have 2 patents, thats enough as they are a real pain to get.
 
I joined this forum just because of this thread. My father in law swears by the old DE filters back in his high school years. He has been trying to figure out where to find one since I'm keeping fish and trying to breed them.

Do you have a list of fittings you used by chance? I didn't see them listed in the thread.
 
That was a very smart design sir! I’m sure it will work fine. You should patent it. I’d buy one. My old vortex diatom filter is somewhere packed away. I need it now to clean a large turtle tank. I’m getting back into the fish hobby soon.
I built one even though I do not have diatoms. I can help with current equipment ie Lead you to the parts all on Amazon. Just so you know in case Paul does not respond
1000001871.jpg
He does not use the powder any more it clumps on the bottom when you try and add it. I told him just a couple of days ago that I almost had that resolved. He replied to me saying he just uses a 5 Micron filter and it works just as well. Also Marineland makes a water clarifier that works fantastic. Its submersible and you can add the powder to it but I don't bother I really like it.
 

TOP 10 Trending Threads

HOW WOULD YOU FEEL ABOUT RECEIVING A FISH OR CORAL AS A HOLIDAY GIFT?

  • I’d love one, as long as it’s a species I chose

    Votes: 22 25.9%
  • I’d trust someone who knows my tank to choose

    Votes: 8 9.4%
  • I’d rather get a gift card and pick it myself

    Votes: 31 36.5%
  • I’d prefer gear or supplies instead

    Votes: 2 2.4%
  • Please don’t surprise me with livestock

    Votes: 22 25.9%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new