Do open air t5 ballast need active cooling

Jonathan Troutt

Well-Known Member
View Badges
Joined
Apr 1, 2018
Messages
974
Reaction score
1,177
Location
Indianapolis, IN
What state or country do you live in
Indiana
Rating - 0%
0   0   0
Basically my ballast are outside of an enclosure exposed to the open room air. Is this passive cooling setup sufficient or do i need to find a way to put a fan on them?
 
Basically my ballast are outside of an enclosure exposed to the open room air. Is this passive cooling setup sufficient or do i need to find a way to put a fan on them?

I the past when I built reef lighting systems with T5's. I always had they exposed to the room air with no fans. They should have built into them a thermal switch to shut them off if they over heat. Some do, some don't. You should be fine.
 
I the past when I built reef lighting systems with T5's. I always had they exposed to the room air with no fans. They should have built into them a thermal switch to shut them off if they over heat. Some do, some don't. You should be fine.
Right on. Im using HEP ballast i would assume these do given they are pretty much the go to ballast for this hobby unless peeps are overdriving.

Give ya an idea on how i have them installed

95E76D5F-59C4-41EF-85F3-A731D673F9F8.jpeg
 
Right on. Im using HEP ballast i would assume these do given they are pretty much the go to ballast for this hobby unless peeps are overdriving.

Give ya an idea on how i have them installed

95E76D5F-59C4-41EF-85F3-A731D673F9F8.jpeg

Should be okay as long as they don't get wet.
 
Should be okay as long as they don't get wet.
The wires will be getting a plastic c-channel like like strip over them as well as any crimp connector getting filled with silicone. I am also going to be installing splash guard underneath the ballast for just in case purposes
 
The wires will be getting a plastic c-channel like like strip over them as well as any crimp connector getting filled with silicone. I am also going to be installing splash guard underneath the ballast for just in case purposes

Good, because you never know when something could happen. :)
 

IF YOU HAD TO OPERATE EVERYTHING ELSE MANUALLY, WHICH AUTOMATED SYSTEM WOULD YOU KEEP?

  • Auto top-off

    Votes: 62 58.5%
  • Automated dosing

    Votes: 6 5.7%
  • Mechanical filtration / roller filter

    Votes: 4 3.8%
  • Automated water testing

    Votes: 3 2.8%
  • Automatic feeding

    Votes: 1 0.9%
  • Lighting schedule

    Votes: 20 18.9%
  • Controller and remote monitoring

    Votes: 4 3.8%
  • Leak detection and emergency shutoff

    Votes: 2 1.9%
  • Automatic water changes

    Votes: 3 2.8%
  • None. I prefer to operate everything manually

    Votes: 0 0.0%
  • Something else (explain in the comments)

    Votes: 1 0.9%
Back
Top
Home
Post thread…
Market
What's new