Euphyllia not feeling ok / not opening fully ?

Katze

Well-Known Member
View Badges
Joined
Dec 27, 2022
Messages
567
Reaction score
115
Location
Hungary, Budapest
What state or country do you live in
Other International
Rating - 0%
0   0   0
Hi everyone
I've bought an euphyllia about 2-3 weeks ago in that time line it was looking pretty good BUT
Last day I've done a waterchange (usual 10%) after that I measured a phosphate of 0.2-0.18 (+dosed 2,5 ml of nopox that day) the week before that one it was only 0.05-0.02
Also I'm not sure but the flow may not be the best had to move it 1x / week in it's current position, where was looking the best so far.
The question what causes this kind of closing up. And I need help resolving this. +everything looks nice other than this coral
current parameters:
Sal.: 1.025-1.026
PO4: 0.2
NO3: 40-30

Light setting: Maxspect ethereal
cool white: ~80%
blue: 90%
green: 30%
red: 30%
warm white: 30%
+ infos
-I did have 2 zoa polyps pop
-I did move my ricordea out of it's hospital container and is relatively close to the euphyllia
-I had to remove a calcinus elegans, since they harassed my zoas

Pictures:
-flow off (notice the white thing at it's mouth, maybe coral slime from stress ?)

euphyllia 1.jpg

flow on
euphyllia 2.jpg
 
When should I expect changes ? I moved the coral to a spot with better flow and a bit more light + I'm planning to buy carbon 2-3 days later
24-48 hours
 
Upvote 0
Thank you again ! (Any experience with hammers + Acan lords ? I may try one if this ends up alive)
 
Upvote 0
24-48 hours
Hey ! So today I took a look at it's tissue under it's tentacles (at the connection of the skeleton and the polyps) and I saw some receding I did measure phosphates today still 0.2 regardless of NOPOX. + I rearranged my flow for this one coral, can it have bad effects on the tank (10months old tank)
 
Upvote 0
Stop the nopox for now.
Do you run a skimmer?
Did you adjust your lights as vette suggested?
Where is the coral now? Did you move it?

I find that mine like to be protected against a wall. One side against/near a wall will help if you can't adjust the flow power. Random flow so they sway.
You can always shoot the power head directly at the wall to break it up and still keep flow.

Receeding flesh is not great. Where are your other parameters? And are they stable?
 
Upvote 0
Stop the nopox for now.
Do you run a skimmer?
Did you adjust your lights as vette suggested?
Where is the coral now? Did you move it?

I find that mine like to be protected against a wall. One side against/near a wall will help if you can't adjust the flow power. Random flow so they sway.
You can always shoot the power head directly at the wall to break it up and still keep flow.

Receeding flesh is not great. Where are your other parameters? And are they stable?
Yes I do run a skimmer. Yes I adjusted the lights. Yes I did move the coral a bit higher up. And I did tweak a bit on my flow.
 
Upvote 0
Hey ! So today I took a look at it's tissue under it's tentacles (at the connection of the skeleton and the polyps) and I saw some receding I did measure phosphates today still 0.2 regardless of NOPOX. + I rearranged my flow for this one coral, can it have bad effects on the tank (10months old tank)
NoPox is not the answer and may be causing issue in part. I would suggest getting a water test at an LFS that does Not use Api kits and have them test your: ammonia-nitrate-ph-Phosphate and see what readings they come up with and to compare with yours also assuring youre not getting false readings.
 
Upvote 0
NoPox is not the answer and may be causing issue in part. I would suggest getting a water test at an LFS that does Not use Api kits and have them test your: ammonia-nitrate-ph-Phosphate and see what readings they come up with and to compare with yours also assuring youre not getting false readings.
got it tho they don't have ammonia test + they use either Hanna or salifer
 
Upvote 0
got it tho they don't have ammonia test + they use either Hanna or salifer
Those are good test. Did they say how nitrate and phosphate looked?
 
Upvote 0
Those are good test. Did they say how nitrate and phosphate looked?
I tested those on my own but I will go to them nextday for activated carbon and I could ask for a test + I use hanna for po4 too
 
Upvote 0
Those are good test. Did they say how nitrate and phosphate looked?
Okay I just came back from my LFS and got a reading of kH: 10 I'll receive the measurement about the po4 next day. + bought some activated carbon
 
Upvote 0
Okay I just came back from my LFS and got a reading of kH: 10 I'll receive the measurement about the po4 next day. + bought some activated carbon
so that high of carbonate isn't that bad ? I know it should be 7-8 max 9
 
Upvote 0
so that high of carbonate isn't that bad ? I know it should be 7-8 max 9

Not necessarily. I personally keep mine at 8, but keeping your dKh anywhere in the 7-12.5 range can be okay. Best is to keep that number, wherever you fall in that range, as stable as possible.

To me, it looks like your (maybe) torch is dealing with some bad bacteria, which can be exacerbated by carbon dosing (like Nopox).

Do you know where your pH goes throughout the day? Do you run a skimmer? What's your normal water change regimine?
 
Upvote 0
Not necessarily. I personally keep mine at 8, but keeping your dKh anywhere in the 7-12.5 range can be okay. Best is to keep that number, wherever you fall in that range, as stable as possible.

To me, it looks like your (maybe) torch is dealing with some bad bacteria, which can be exacerbated by carbon dosing (like Nopox).

Do you know where your pH goes throughout the day? Do you run a skimmer? What's your normal water change regimine?
10%/week, YES I do run a skimmer and I can't measure PH (I used universal indicator paper once and it said 6-7 but it was an ultra low grade product)
 
Upvote 0
so that high of carbonate isn't that bad ? I know it should be 7-8 max 9
actually range is 8-11dkh and never go by mine or others alk level as each will differ based on consumption level and number/type of reef (mixed, SPS dominant, etc) 10 is acceptable but realize you have to balance with calcium levels as they work together
 
Upvote 0
actually range is 8-11dkh and never go by mine or others alk level as each will differ based on consumption level and number/type of reef (mixed, SPS dominant, etc) 10 is acceptable but realize you have to balance with calcium levels as they work together
I had to move it again, I do see an improvement + I can't see the mouths anymore but It's still not opening fully and I have no idea why.
 
Upvote 0
I had to move it again, I do see an improvement + I can't see the mouths anymore but It's still not opening fully and I have no idea why.
New location - I would give it at least a day or two to see how it adapts . Constant moving or changes will only stress it
 
Upvote 0
New location - I would give it at least a day or two to see how it adapts . Constant moving or changes will only stress it
Well honestly I changed it's location 2 days ago that's why I'm worried nothing worked so far
 
Upvote 0
New location - I would give it at least a day or two to see how it adapts . Constant moving or changes will only stress it
I've got three questions 1st What PAR would you recommend ? I did some research, some said 50-150 and others 150- 250
2nd Which are the signs for too high flow or too low flow and the same with light.

3rd I'm starting to get interest in diping it would you recommend it and if yes what to dip in or it would worsten it's current state?
 
Upvote 0

TOP 10 Trending Threads

HOW DO YOU HANDLE HOLIDAY DECORATING AROUND YOUR REEF?

  • I decorate the tank or stand

    Votes: 1 33.3%
  • I decorate AROUND the tank or stand

    Votes: 1 33.3%
  • I add one small seasonal touch but keep it very basic

    Votes: 0 0.0%
  • I take a holiday photo, but don’t decorate the space

    Votes: 0 0.0%
  • I leave the reef area as it is

    Votes: 1 33.3%
  • We don’t decorate for the holidays

    Votes: 0 0.0%
  • Other (Post in the comments)

    Votes: 0 0.0%
Back
Top
Home
Post thread…
Market
What's new