HYDROS FW186/APP199 Now Live!

[JeffB418]

Firmware 186 / App 199 now live!
Firmware update is for ALL HYDROS devices.
IMPORTANT: You must have app 199 BEFORE updating to firmware 186!
NOTE: If your app does not prompt you for an update or you do not see the latest version on the firmware update page, it means you are not running the latest app. Check the app store and download the new version!
For more information on all the changes and new features, visit https://forum.coralvuehydros.com/th...RGTOlsGhA66F9FECGduQuffHSBy5P5Jl_C9b_X1oI83hg

 

[JeffB418]

Also if you are updating a WAVE ENGINE or ICE CAP CONTROLLER to this new version of FW, you MUST push the UPDATES REQUIRED/UPLOAD CHANGES after installing the new firmware to complete the process.

 

[Yevoc]

Kinda stuck here.
https://www.reef2reef.com/threads/hydros-failed-after-update.832861/

 

[JeffB418]

FYI Carlos updated the instructions PLEASE READ THESE FULLY BEFORE UPDATING and added some trouble shooting tips for anyone who is having issues. https://forum.coralvuehydros.com/th...engine-icecap-controller-to-186-firmware.750/

Also PLEASE DO NOT make a collective unless you have both a command bus cable for each device link AND a terminator!

Finally, if you have accidentally created a collective of 1 device and downloaded the new app (199) you will need to reach out to support.coralvue.com before proceeding. You won’t be able to download the new fw without help.

 

[Karliefish]

Since upgrading to the latest version my vortech pumps no longer work properly. Prior to the new version I set my MP60s to run opposite (sine wave). They worked perfectly…the pump would throttle-up on the one end of the tank while the other pump would throttle down. You could see the white light dots on the Vortech controllers going up and down. Now since loading the new firmware version my Vortech pumped just run in constant mode and I can no longer control them. And yes I have gone through the whole process to re-pair the Vortech controllers with the hydros wave engine.
Anyone else having this problem? Help - thank you.

 

[JeffB418]

Since upgrading to the latest version my vortech pumps no longer work properly. Prior to the new version I set my MP60s to run opposite (sine wave). They worked perfectly…the pump would throttle-up on the one end of the tank while the other pump would throttle down. You could see the white light dots on the Vortech controllers going up and down. Now since loading the new firmware version my Vortech pumped just run in constant mode and I can no longer control them. And yes I have gone through the whole process to re-pair the Vortech controllers with the hydros wave engine.
Anyone else having this problem? Help - thank you.

Send a message to support.Coralvue.com and they can look into it