Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
I held down mode and set until it flashed red white and blue, then mode until purple and red, and then power button until it reset.Did you factory reset the driver?
Tried that. Tried turning on airplane mode as well. Super weird because when this chip was in my Vectra it works just fineTry closing the app completely, power cycle the vortech and then try to push the update
Nothing will show up there though, I cannot get the MP40 to show in there.Try going to SETTINGS > TROUBLESHOOTING > VERIFY SETTINGS.
See what's corrupted with that VT
Does it show up in DEVICES?Nothing will show up there though, I cannot get the MP40 to show in there.
Tried reseting again and its still thereOh! My mistake, I thought you were beyond that.
That red icon on the top right indicates that the factory reset didn't take....
Can you do it again?
VorTech Propeller Pump Controller Reset
Overview EcoSmart and QuietDrive VorTech Controllers have 2 different resets available to you. To perform a soft or hard Reset, see their descriptions and instructions below.Soft Reset: Clears the...support.ecotechmarine.com
Yea.. as soon as I thought about the vectra still showing up on Mobius without the chip, I deleted it. So not 100% sure what else...I'm only speculating here, I wonder if there's a conflict with that rf coming from a vectra.
I'm at a loss as well... you'll have to reach out to ecotech cs.
Completely closing the app or better yet restarting the phone/device, then factory reset the driver should've worked.
Another long shot is to put the chip back in the vectra, go through the motions to remove it from mobius. And then factory reset the vectra.Yea.. as soon as I thought about the vectra still showing up on Mobius without the chip, I deleted it. So not 100% sure what else...
Nothing… thanks for the help. I will contact mobius MondayAnother long shot is to put the chip back in the vectra, go through the motions to remove it from mobius. And then factory reset the vectra.
Then put the rf chip in the vortech and see if that makes a difference?
Will do. Going to pull a chip from one of my xr30s. See if it’ll update then swap it back.Please reply back to let me know what the solution is