Need help PacificSun Calcium reactor

[Holst]

Hi everyone.
I just bought a Seconda hand Calcium Reactor with CalcFeed controller.

I just set it up in my kitchen trying to figure out how it works. But it is like it's sucking the water back into the reactor so the water level rises above the Co² optical sensor and then it opens for the CO² again. This happens all the time with only 10 seconds apart.

The water going into the reactor and out again is lower than the reactor itself..
Any ideas ?

 

[KrisReef]

Not sure, but I thought that the CO2 optical sensor was supposed to detect CO2 in liquid, not it air/gas?

Either way, I feel your pain! Good luck getting this operational and steady.

Edit. Hmm, supposed to measure the incoming gas without water in the chamber? Again, good luck!

 

[Sean Clark]

These are not your average calcium reactors. They are above average for sure.

Here is the link to the manual from PacSun's website. Hopefully it helps you get going.

CalcFeeder PRO English Instruction manual V1 and V2

 

[Holst]

Not sure, but I thought that the CO2 optical sensor was supposed to detect CO2 in liquid, not it air/gas?

Either way, I feel your pain! Good luck getting this operational and steady.

Edit. Hmm, supposed to measure the incoming gas without water in the chamber?

Not sure, but I thought that the CO2 optical sensor was supposed to detect CO2 in liquid, not it air/gas?

Either way, I feel your pain! Good luck getting this operational and steady.

Edit. Hmm, supposed to measure the incoming gas without water in the chamber? Again, good luck!

Again, good luck!

Thought the same.. I’m gonna call the support..