Orphek Bar on ATI Fixture

[vetteguy53081]

What do you mean?

With customers paying for the light and getting hit with tariff and charges.

 

[levi83]

With customers paying for the light and getting hit with tariff and charges.

Gotcha. I just ordered from Amazon. I hope I don’t get that crap.

 

[vetteguy53081]

Gotcha. I just ordered from Amazon. I hope I don’t get that crap.

Amazon will have taken care of that. I dont think you will. Its those who order direct from orphek

 

[nhbegli]

Best pic i have at the moment since im at work . I am running the UV on the backside and skyblue on the front side.
I really like them .

What screw/washer combo do you have there attaching your OR3 to the T5s? I am looking to do the same

 

[vetteguy53081]

What screw/washer combo do you have there attaching your OR3 to the T5s? I am looking to do the same

You can use l-brackets from Home depot

 

[Saltysav96]

What screw/washer combo do you have there attaching your OR3 to the T5s? I am looking to do the same

its been a few years but if i remember correctly i think i just used some self taping screws my dad had laying around at the time. i eventually added on a another bar ( 2 on each side) using a strip of metal that i found in the hardware section at lowes in one of the "specialty hardware" drawers.

the idea @vetteguy53081 is good too and can also be attached with some self taping screws unless you wanna get all fancy and actually tear the whole fixture apart and put in a small bolt/nut/washer on the inside

 

[nhbegli]

its been a few years but if i remember correctly i think i just used some self taping screws my dad had laying around at the time. i eventually added on a another bar ( 2 on each side) using a strip of metal that i found in the hardware section at lowes in one of the "specialty hardware" drawers.

the idea @vetteguy53081 is good too and can also be attached with some self taping screws unless you wanna get all fancy and actually tear the whole fixture apart and put in a small bolt/nut/washer on the inside

Ended up using a size 8 bolt with a washer between the OR3 bracket mount and the ATI, and then 2 nuts on the inside of the ATI to hold it all in place. It was the perfect combo and the OR3 sits super cleanly on the ATI