Popbloom RS90 controller wiring

[Reefology1]

it is easy to support GHL/Apex, I have done it for some friends.
the following step FYI.
1, find out a waterproof cords to connect the GHL/Apex to the light. (just like controller). I am happy to give you it FREE and you only pay the shipping cost.
2, connect the Ch1 (blue cord) to GHL/Apex 1. .... 2...3...4. and set the GHL/APex high pulse (10V ) is on.
3, connect the FAN to GHL/Apex, and set low pluse (0V) is on.
4, connect the GND to GHL/Apex GND.
5, using the GHL/Apex power itself.

Please do not hesitate to let me know if you need my hands.

Maybe the detail electrical issue is too boring for most,but maybe very attractives to others .
Would please may it possible you open a new topics (forums ) do discuss them. such as (GHL/APex replace PopBloom Turing controller)

Hi @Oliver@DSunY, I'd like to hook the DS90's to my aquarium controller but don't want to take the connector off the PopBloom controller in case I need to reuse it. Can you please provide some more detail like the pinout as well as the type of 8 pin connector required?

thank you

 

[Gumbies R Us]

Did you get this figured out?

 

[Reefology1]

yes I did, found this on Ali express:

https://www.aliexpress.com/item/4001065237679.html?spm=a2g0o.order_list.order_list_main.106.25b21802y6v5YT

Popbloom Cable colors:
Black and orange - ground
Blue - white Channel
Yellow - blue channel
White - cyan channel
Green - moon light
Brown - fan
Red - 24vdc

I have it connected to my Reef Angel 0-10v PWM signal and working great with the exception of the fan. Not sure how to set it to run at different voltages? I just leave it unplugged and it stays on at 0v as @Oliver@DSunY suggests. I need to take my lights down at some point to play with the fan but I'll do that at some other time. If anyone has any suggestions, Please let me know.

The red cable is used to power the stock controller but not need.

Cheers