Bambu specifically instucts not to use alcohol on their plates.
warm water and soap.
I've been looking at the site below. They are supposed to make some pretty bad dupa build plates. Not cheap but may be worth it.
Sweet, looks like the CFX plate is the only one the recommend for use with PP, but would still need magigoo'd.
I watched a video where they said that textured plates are an issue with PP because it leaves tiny areas that the tape/glue/whatever don't get into which allows it to break free since it likes itself so much more than anything else.
That would align with my experiences. The PEI bed worked fine for about 2 hours, then the raft would slowly work its way out from the middle and once popped off, the whole print would slide around at will. While printing you can watch the print fighting the raft to rip itself off the print bed. When i was printing on tape, the biggest issue was that the print was pulling the tape adhesive off the bed. It was still attached to the tape, but would warp so hard it would delaminate the tape from the print bed. Wild stuff.
Yes, I had bought a couple of Biqu CryoGrip Pro Glacier plates before the printer arrived. The reason I bought two is because I somehow put two in my cart and never noticed. When they arrived I was like, "Hey! What's going on here? They sent me two plates." Looked up the order and gave the ol', "Oh well." to myself. Then my wife asked me why I bought two of them and I gave her my standard answer of, "More is better."
More is better with plates. One can be printing while the other is drying after cleaning and they do get damaged (I ripped the coating off of a Bambu Smooth PEI plate trying to get a PETG print off of it and I scratched a Creality PEI from a z-offset mishap).
Good luck with the nuisance algae. And man sorry about the Poletti! all that work to grow a perfect shaped acro.Tank developments:
First off, how the flip?! Poletti snapped off at the trunk, no obvious culprit.
And B:
I officially give up, going to dose some fluxRx and be lazy for my bryopsis issue this weekend. The final straw was that it started growing on my dendro skeleton and is irritating it. Nobody messes with dendro!
Silver lining i guess. I'm going to try and super glue it back together, ive had luck doing that befor, but never with such a large piece. How it got there though is still one for "unsolved mysteries"Good luck with the nuisance algae. And man sorry about the Poletti! all that work to grow a perfect shaped acro.
Maybe some grace that it didn’t snap before the end of the grow out?!?
Yeah that’s a pretty thick stalk. Do you have any larger fish? So weird
Chris is not allowed to pick on me for that one 
Haha, good luck with that one!Yeah that’s a pretty thick stalk. Do you have any larger fish? So weird
Stalk referencing stick of acro nothing else
What printer do you have
Ender 3 Max Neo.
I found 3-4 in my bubble plate thriving! Love these guys.Found some strays in the skimmer cup!
3 baby trochus snails:
To think I paid you not one, but two, nice compliments yesterday and one of them was specifically about your sense of adventure. Then you make a comment like this bashing all my good will towards you. Apparently, you're just another user. Use me when it suits you and than destroy me like a couple of Aiptasia. It's ok, though, as life has long-ago prepared me for people like you. I will, once again, have to say, "It's okay, Chris. Scott is just another damaged spirit who got chewed up and spit out. Have some pity and let him be him and use you."Yeah that’s a pretty thick stalk. Do you have any larger fish? So weird
Stalk referencing stick of acro nothing else
