i did sudo before that line but i get a permission denied replycurl -u <user>:<password> http://<reef-pi IP>/api/timers > timers.json
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
i did sudo before that line but i get a permission denied replycurl -u <user>:<password> http://<reef-pi IP>/api/timers > timers.json
Interesting,
I am planning to drive the dosers with ph probe feedback at the end.
I think the rj11 based control works same as kessil controller. But not sure. Is this a jebao doser ?
I plan to implement programmability (this is similar to feed mode) as part of the 2.0 release. I am still brain storming on the type of interface.
What salt you went with?
Awesome! Thanks for the continued support and build. Time to order some pH supplies. Just the chip and probe?Hi
I have cut a new release of reef-pi , 1.4.
This release contains couple of important changes:
There is no doc on the new features yet, they;ll come in due time, if you are planning to use any of them, let me know , I can share some details, but they should be intuitive mostly. pH probe details are mostly covered by atlasscientific documents itself
- pH sub- system. reef-pi now has ph monitoring capabilities. Users can now add ph probes (more than one), calibrate them through the UI, and configure them to monitor tank ph at a fixed interval and alert based on it. This new subsystem likely to see some changes, like equipment control based on ph etc. But anyone wants to monitor ph, should be up and running.
- Camera sub module received a lot of new updates. Notably an image browser UI and streaming video UI using motion.
release builds can be found in usual location: https://github.com/reef-pi/reef-pi/releases/tag/1.4
At a minimumAwesome! Thanks for the continued support and build. Time to order some pH supplies. Just the chip and probe?
Yes. You mean this one:Super !
Quick question, can I simply upgrade with the upgrade command in ssh?
Yes, i was reading that page exactly lolYes. You mean this one:
https://reef-pi.github.io/additional-documentation/upgrade/
At a minimum
- pH probe
- ezo circuit
- Famale bnc connector
Its good to have some sort of calibration solution, does not necessarily have to be atlas scientific ones.. I think the probe can also be from different verndor, but I have not tried anything else yet, so cant confirm. ezo circuit have to be from atlasscientific, thats the part reef-pi depends on.
Yes .Do I have to buy an EZO circuit for each ph probe?
And probably a voltage isolator as wellYes .
reef-pi UI should show themYes, i was reading that page exactly lol
another question.. i did the mistake of not writing down all my GPIO pins, and my PI3 is kinda in a no reach place lol
can i find the info on waht GPIO i have on what relay with a ssh command before i wipe it all off ?
here is a screenshot of mine version 1.0reef-pi UI should show them
Hmm.. can you run this commandhere is a screenshot of mine version 1.0
curl -u <user>:<password> http://<reef-pi IP>/api/outlets
curl -u ranjib:password http://10.0.0.17/api/outlets
I went with the pH kit, which comes with probe+ezo+bnc connector + 3 calibration solution + storage solution and cost 180$. I have not checked how much each of them individually will cost. After couple of months of testing, I 'll try to build a cheaper version (probably swap out probe and bnc connector) that will bring down the cost to below 100$.